Tuesday, January 7, 2014

Circuit Analysis

CIRCUIT ANALYSIS by ETR 113 June 08, 2011 Instructor PURPOSE The objective of this lab is to give the given travel shown in presage 1 use assorted resistors (between 100 Ohm and 1 billion Ohm). Then, prove assort Circuit abbreviation and go theorems. system In this lab in that respect be ii theorems being introduced and analyzed: The first is class Current digest and the second is run Analysis. Before rise the lab, there are four move that must be followed in this chuck together. These go are as follows: 1.) Calculate- Build your roach on paper first. Do calculations for Branch Circuit Analysis (BCA) then(prenominal) Mesh Analysis (Mesh). Record calculated findings in remit II. 2.) Multi-Sim- It is important to pee-pee your circuit in Multi-Sim and to harmonise your BCA and Mesh calculations against the calculations in Multi-Sim. 3.) Build and Measure Next physically, build your circuit on the Elvis circuit board, supply get cast of powerfulness using both the Elvis-Variable Power Supply (VPS) and another(prenominal) power supply source. Take measurements and record measured info in tabularize II. 4.) Conclude Finally, compare your mathematical calculations for both BCA and Mesh to both Multi-Sim and the circuit that was built by work surface percent errors. Low percent errors are a impartial sign of accuracy.
bestessaycheap.com is a professional essay writing service at which you can buy essays on any topics and disciplines! All custom essays are written by professional writers!
Higher percent errors means that something such as calculations, devices or materials have caused accuracy flaws in the lab. Depending on how lavishly the percent errors are the lab can either be redone or the flaws can be explained. Now that the four steps ha! ve been explained, measure 4 assorted resistors ranging between (1k? and 20 k?). Record these measured values in Table I. Next, begin the calculations for Branch Current Analysis. In establish to do BCA there are seven steps to follow, they are as follows: * (1) Find a node and assume directions of currents. * (2) Do a KCL equation for the currents at the node. * (3) Write down each resistor voltage drop...If you want to get a full essay, order it on our website: BestEssayCheap.com

If you want to get a full essay, visit our page: cheap essay

No comments:

Post a Comment

Note: Only a member of this blog may post a comment.